To confirm that this part fits your vehicle, please enter your vehicle's details below.
This part is compatible with 0 vehicle(s).Show all compatible vehicles
This part is compatible with 1 vehicle(s) matching
This part is not compatible with
Eachine Beecore Upgrade V2.0 Brushed F3+OSD Flight Control Board For Inductrix Tiny Whoop E010 E010S
Note: The FLYSKY Version will be replaced by Black PCB.
User Manual, Please select Download
1. Frsky receiver
2. DSM2/DSMX receiver
3. Flysky receiver
Eachine Beecore V2.0 Brushed Flight Control Board is a new upgraded version which integrated Betaflight OSD and MPU6000 at SPI bus. The new version also integrated 2.4G receiver with 3 versions to choose(FRSKY/FLYSKY/DSMX). It's the best flight controller for indoor brushed quadcopter (BeeDuctrix / Tiny Whoop / Inductrix setups/Eachine E010 E010C E010S ect.).
6 A-xis: MPU6500
ESC: All FETs are rated at 10A maximum
Work voltage: 3.5V-4.35V / 1S Lipo battery input
Firmware Version: BETAFLIGHTF 3.2.0 Firmware Target: Omnibus
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Size: 26mm x 26mm (Fully compatible with the Inductrix quad and Eachine E010/E010S frame and mounting pattern.)
Receiver option: Frsky 8CH protocol D8 Mode (SBUS)
Flysky 6CH AFHDS 2A protocol (IBUS)
Spektrum DSM2/DSMX protocol
1.The world's first F3_EVO controller compatible for Frsky/Flysky/DSM2 (Optional).
2.BETAFLIGHTF ready, suit for a-cro flight controller for the BeeDuctrix / Tiny Whoop / Inductrix quad!
3.Full Cleanflight/Betaflight compatibility on a STM32 F303 F3_EVO 3x1 style processor.
4.Fully programmable through Cleanflight / Betalfight using the onboard USB port! Tune all the parameters, PID's, and rates to your perfect settings!
5.High discharge battery connector wire for more power and performance.
6.Can fly your Inductrix style quad in full rate mode (or even air mode!), fully execute flips/ rolls, and shoot the smallest of gaps with pre-cision! Tuned to give you that locked in feeling you get with standard race quads.